aticof I'm trying to use my Jumper T16 as joystick in MP, the bars move properly on the Servo Output tab, SERVOn_FUNCTION=1, servo powered, MANUAL mode, but the servo doesn't move..., any suggestions?
Sinamics Make sure that the servo output channel is properly configured in Mission Planner. You can do this by going to the "Config/Tuning" tab and then selecting the "Outputs" tab. Check that the correct output channel is selected for the servo you are trying to control. Make sure that the servo is properly connected to the flight controller. Check the wiring to ensure that the servo is receiving power and that the signal wire is connected to the correct output channel on the flight controller. Check the servo itself to make sure that it is functioning properly. You can do this by connecting the servo directly to a servo tester, or by using a separate radio transmitter and receiver to control the servo.
