RPICam 2.1 problem, ENOSPC will not enable

MortenM

As said I get an error trying to get this to work. What I have tried so far : Enabling camera, increasing gpu mem to 160, updatet software, updated firmware. Was going to move 1-wire pin to GPIO 18, but I Dont have write permission, and dont know how to get it.... Anyway, Im stuck. Heres the logdump...

picam 
mmal: mmal_vc_component_enable: failed to enable component: ENOSPC
mmal: camera component couldn't be enabled
mmal: main: Failed to create camera component
mmal: Failed to run camera app. Please check for firmware updates

Setter rørledning til PAUSE
Rørledningen forbereder ...
Rørledning er forberedt ...
Setter rørledning til SPILLER ...
New clock: GstSystemClock
Fikk EOS fra element «pipeline0».
Execution ended after 0:00:00.000265677
Setter rørledning til PAUSE
Setter rørledning til KLAR ...
Setter rørledning til NULL ...
Frigjør rør ...

Sinamics

MortenM Have you enabled PiCam in Raspberry configuration.

type sudo raspi-config

select camera and choose enable.

MortenM

Yup. First thing I did.....

Sinamics

MortenM check the ribbon cable is inserted correct way. Rpi is not able to communicate with the camera.

MortenM

Ribbon was right way. However it seems like I broke the rpi when I was fiddeling with the cable.... It will not boot....

MortenM

OK. From reading, when i type

vcgncmd get_camera

I get

supported=1 detected=1

But I still get the error message. It seems to indicate a faulty camera unit...

Tested it on a RPI 2....

Sinamics

MortenM have you changed any default values, such as fps or bitrate? If so, then set them back to default. I can remote in to your rpi later today if you want me to have a look.

MortenM

dont think I have changed anything....
If youhave time it would be nice.