uavcast 5.x goes open-source

Sinamics

Hi fellas.
I just want to inform you about my next version for uavcast will be open-source in hope that the community will contribute and make this project even better.

Version 5.x has been re-written from the ground up, and currenlty at 30% completed.
Allot remains and i do not find the time and effort to complete this project within a timely manner, hence going open.

At some point the version 5 will be the superior compared to version 4, and at that time i will probably close my store, or sell support instead of software if that makes sense.

I will add a notice in my store shortly, but it will probably take another year before we have a stable version 5.x

Feel free to collaborate or test it out. Enjoy 🚀
https://github.com/sinamics/uavcast

punitvaya

Sinamics
want to run on windows

BillyLam

Have not checked out the community since the start of Covid, nice to be back. And thanks for the great work!

smokingman

nice to meet you And thanks for opening the source.
I am using version 5.0 now.
RasPi4 + F765-Wing
There was a problem with the default UART, but I am using another UART of the Raspberry Pi 4.
RasPi4 GPIO PIN8, PIN10 -> GPIO PIN27, PIN28
UAVCAST WEB -> FC Controller -> FC Internal Address -> /dev/ttyAMA1
If I can be of any help, I will give a lot of feedback.
Thank U

Ottzin

nice to meet you. It's great to see something amazing by learning about it.

Steven

Hello, dear sir, I have a special payment question about UAV cast pro and I need to ask you about the details of long-range 4G flight. How can I get in touch with you?

Sinamics

Steven shot me a mail at uavmatrix@uavmatrix.com

Steven

Sinamics sir have done. have you get it?

d18911238888

Hello, may I ask if there are any restrictions on the number of clients in your system software? We would like to adopt it. It would be best to provide a detailed introduction and send it to my email. ( d18911238888@126.com )

thank you